How To Remove Built In Bathroom Sink Stopper

How to Remove a Built-in Bathroom Sink Stopper

Bathroom sink stoppers play a vital role in preventing water from draining out of the sink, allowing you to fill it up for various purposes such as washing your hands, brushing your teeth, or shaving. However, these stoppers can sometimes become stuck or clogged, making it necessary to remove them for cleaning or replacement. In this article, we will provide a step-by-step guide on how to remove a built-in bathroom sink stopper, ensuring a smooth and hassle-free process.

Tools and Materials You'll Need:

Pliers (optional)
Small screwdriver (optional)
Washcloth or small towel

Some built-in sink stoppers have a small hole on the top that allows you to remove them using a suction cup or plunger. If your stopper has this hole, you can skip the following steps and proceed to the "Using a Suction Cup or Plunger" section.

Removing the Stopper with Pliers:

Step 1: Locate the Set Screw

Examine the underside of the sink or the drain assembly and look for a small screw. This screw is typically located in the center of the stopper or on its side. It may be covered by a cap or plug, which you can remove using a small screwdriver.

Step 2: Loosen the Set Screw

Using the pliers, gently loosen the set screw by turning it counterclockwise. Be careful not to overtighten or strip the screw.

Step 3: Remove the Stopper

Once the set screw is loose, you should be able to pull the stopper straight up and out of the drain.

Removing the Stopper with a Screwdriver:

Step 1: Locate the Tabs

Look for small metal or plastic tabs around the underside of the sink or the drain assembly. These tabs hold the stopper in place.

Step 2: Depress the Tabs

Using the screwdriver, gently depress each tab one at a time. The stopper should release and fall into the sink.

Using a Suction Cup or Plunger:

Step 1: Wet the Hole

Slightly wet the hole on the top of the stopper using a damp washcloth or small towel.

Step 2: Apply the Suction Cup or Plunger

Place the suction cup or plunger over the hole and press down firmly to create a seal.

Step 3: Pull Up

With the suction cup or plunger firmly attached, pull straight up to remove the stopper.

Tips for Removing Stuck Stoppers:

If the stopper is stuck and difficult to remove, try the following tips:

Use a penetrating oil or lubricant around the base of the stopper.
Gently tap the stopper with a hammer or mallet (avoid striking it directly).
Use a pair of needle-nose pliers to grip the stopper and pull it out.

Conclusion:

Removing a built-in bathroom sink stopper can be a straightforward task if done correctly. By following the steps outlined in this guide, you can effectively remove the stopper and address any clogging or maintenance issues. If you encounter any difficulties or the stopper remains stuck despite your efforts, it is advisable to seek professional assistance from a plumber.

How To Remove A Bathroom Sink Stopper Take Out Pop Up Drain From

Quick Tip 26 Pop Up Stopper Sticks Misterfix It Com

How To Remove A Sink Stopper The Home Depot

When Permanently Removing A Mechanical Bathroom Sink Stopper How Do You Prevent Water Leakage From The Hole Where Horizontal Pivot Rod Was Should Whole Tailpiece Be Replaced To Avoid This