How To Remove Tile In Bathroom Floor

Removing bathroom floor tiles is a project that can be done by DIYers with the right tools and knowledge. By following these steps, you can remove the old tiles and prepare the subfloor for new ones.

1. Preparation

Before you start removing the tiles, you need to prepare the bathroom. This includes clearing the room of any furniture or fixtures, and protecting the walls and floors from dust and debris. You should also turn off the water supply to the bathroom and disconnect any electrical fixtures.

2. Remove the Grout

The first step in removing the tiles is to remove the grout that holds them in place. You can do this with a grout saw or a utility knife. Be careful not to damage the tiles when you are removing the grout.

3. Remove the Tiles

Once the grout has been removed, you can start removing the tiles. You can do this with a hammer and chisel, or a tile removal tool. If you are using a hammer and chisel, be careful not to damage the subfloor. If you are using a tile removal tool, follow the manufacturer's instructions.

4. Clean the Subfloor

Once the tiles have been removed, you need to clean the subfloor. This includes removing any remaining grout or adhesive, and sanding the subfloor to smooth it out. You may also need to repair any damaged areas of the subfloor.

5. Install the New Tiles

Once the subfloor is clean and prepared, you can start installing the new tiles. Start by applying a thin layer of mortar to the subfloor. Then, place the tiles on the mortar and press them into place. Use a level to make sure that the tiles are level, and use spacers to keep the tiles evenly spaced.

6. Grout the Tiles

Once the tiles have been installed, you need to grout them. Grout is a mixture of cement, sand, and water that fills the gaps between the tiles and helps to hold them in place. Apply the grout to the tiles with a grout float, and then use a sponge to remove any excess grout. Allow the grout to dry for 24 hours before walking on it.

7. Seal the Grout

Once the grout has dried, you should seal it to protect it from water and stains. Apply a grout sealer to the grout with a brush or sponge, and allow it to dry for 24 hours.

Conclusion

Removing bathroom floor tiles is a project that can be done by DIYers with the right tools and knowledge. By following these steps, you can remove the old tiles and prepare the subfloor for new ones.