How To Replace A Bathroom Sink Plug

How to Replace a Bathroom Sink Plug

A bathroom sink plug is a small but essential part of any bathroom, that helps to prevent water from draining out of the sink. Over time, sink plugs can become worn or damaged, and need to be replaced. Replacing a bathroom sink plug is a relatively simple task that can be completed in a few minutes with a few simple tools.

Materials you'll need:

New bathroom sink plug
Adjustable wrench or pliers
Putty knife or flathead screwdriver
Plumber's putty

Step 1: Turn off the water supply

The first step is to turn off the water supply to the sink. This is typically done by turning off the valves located under the sink. Once the water supply is turned off, open the faucet to release any remaining water in the lines.

Step 2: Remove the old drain plug

Once the water supply is turned off, you can remove the old drain plug. To do this, use an adjustable wrench or pliers to loosen the nut that holds the plug in place. Once the nut is loose, you can remove the plug by hand.

Step 3: Clean the drain hole

Once the old drain plug is removed, take a moment to clean the drain hole. You can use a putty knife or flathead screwdriver to remove any debris or old plumber's putty. This will help to ensure that the new drain plug fits properly.

Step 4: Apply plumber's putty

Before installing the new drain plug, apply a bead of plumber's putty around the base of the plug. This will help to create a watertight seal and prevent leaks.

Step 5: Install the new drain plug

Once the plumber's putty is applied, insert the new drain plug into the drain hole. Hand-tighten the nut to secure the plug in place. Once the nut is hand-tight, use an adjustable wrench or pliers to tighten it further. Be careful not to over-tighten the nut, as this can damage the plug or the sink.

Step 6: Turn on the water supply

Once the new drain plug is installed, turn on the water supply and check for leaks. If there are any leaks, tighten the nut further. Once the plug is secure and there are no leaks, you can use the sink as normal.

Replacing a bathroom sink plug is a simple task that can be completed in a few minutes with a few simple tools. By following these steps, you can ensure that your sink plug is properly installed and will prevent leaks.