How To Replace A Bathroom Tub Spout

How to Replace a Bathroom Tub Spout

A bathroom tub spout is a relatively simple plumbing fixture to replace. With a few basic tools and a little bit of time, you can easily do it yourself. Here's a step-by-step guide to help you get the job done:

Step 1: Gather your tools and materials.

Adjustable wrench
Channel lock pliers
Plumber's putty
New tub spout
Teflon tape

Step 2: Turn off the water supply.

Locate the water supply valves under the sink and turn them off. If you don't know which valves to turn off, turn off the main water supply to your home.

Step 3: Remove the old tub spout.

Use the adjustable wrench to loosen the nut that holds the spout in place. Once the nut is loose, you can remove the spout by hand. If the spout is stuck, you can use the channel lock pliers to gently pry it loose.

Step 4: Clean the threads on the tub spout connection.

Use a rag to clean the threads on the tub spout connection. This will help to ensure that the new spout will fit properly.

Step 5: Apply plumber's putty to the threads of the new tub spout.

Roll a small amount of plumber's putty into a thin rope and apply it to the threads of the new tub spout. The putty will help to create a watertight seal.

Step 6: Wrap Teflon tape around the threads of the new tub spout.

Wrap the Teflon tape around the threads of the new tub spout in a clockwise direction. The tape will help to prevent leaks.

Step 7: Install the new tub spout.

Hand-tighten the new tub spout onto the tub spout connection. Once the spout is hand-tight, use the adjustable wrench to tighten it further. Be careful not to overtighten the spout.

Step 8: Turn on the water supply and check for leaks.

Turn on the water supply valves under the sink and check for leaks. If there are any leaks, tighten the nut on the tub spout until the leak stops.

Congratulations! You have now successfully replaced your bathroom tub spout.