How To Replace A Washer In Bathroom Mixer Tap

A leaky bathroom mixer tap can be a frustrating problem, but it's one that can be easily fixed with a few simple tools and a little bit of know-how. One of the most common causes of a leaky tap is a worn-out washer, which is a small rubber or plastic disc that creates a seal between the tap body and the handle. Replacing a washer is a relatively simple task that can be completed in just a few minutes.

To replace a washer in a bathroom mixer tap, you will need the following tools:

* A flathead screwdriver * A pair of pliers * A new washer

Once you have gathered your tools, follow these steps:

Turn off the water supply to the tap.

This is typically done by turning off the stop valves located under the sink. 2.

Open the tap to release any remaining water.

Remove the tap handle.

This is usually done by unscrewing the screw that holds the handle in place. 4.

Remove the tap cartridge.

The tap cartridge is the part of the tap that contains the washer. It is usually held in place by a nut or a clip. 5.

Remove the old washer from the tap cartridge.

The old washer will be located on the bottom of the tap cartridge. Use a pair of pliers to gently pry the old washer off. 6.

Install the new washer on the tap cartridge.

Make sure that the new washer is facing the correct direction. 7.

Reassemble the tap.

Reassemble the tap in the reverse order that you disassembled it. 8.

Turn on the water supply to the tap and check for leaks.

If there are no leaks, then you have successfully replaced the washer.

Replacing a washer in a bathroom mixer tap is a simple task that can be completed in just a few minutes. By following these steps, you can easily fix a leaky tap and save yourself the cost of calling a plumber.