How To Replace A Washer In Bathroom Sink Drain Plug

How to Replace a Washer In a Bathroom Sink Drain Plug

A bathroom sink drain plug can become worn out over time, which can cause water to leak out of the sink when the plug is closed. If you are having this problem, you may need to replace the washer in the drain plug. Replacing a washer is a relatively simple and inexpensive repair that you can do yourself with a few basic tools .

Tools and Materials You Will Need

Replacement washer (available at most hardware stores)
Adjustable wrench
Screwdriver
Bucket
Cloth

Step-by-Step Instructions

1. Turn off the water supply to the sink. There are usually two shut-off valves under the sink, one for the hot water and one for the cold water. Turn both valves clockwise to turn off the water.

2. Remove the drain stopper. Most drain stoppers are held in place by a screw. Use a screwdriver to remove the screw, then pull the drain stopper up and out of the drain.

3. Remove the old washer. The old washer is usually located on the bottom of the drain stopper. Use a pair of pliers to remove the old washer.

4. Place the new washer on the drain stopper. Make sure that the new washer is the same size and shape as the old washer.

5. Reinsert the drain stopper. Push the drain stopper back into the drain hole. Make sure that the washer is seated properly on the drain.

6. Tighten the screw. Use a screwdriver to tighten the screw that holds the drain stopper in place.

7. Turn on the water supply to the sink. Check for leaks around the drain plug. If there are any leaks, tighten the screw further.

Tips

If you are having trouble removing the old washer, you can try using a pair of needle-nose pliers.
If the new washer does not fit properly, you may need to replace the entire drain plug.
If you are still having problems with the drain plug after replacing the washer, you may need to call a plumber.