How To Replace Basin Mixer Taps In The Bathroom

How to Replace Basin Mixer Taps in the Bathroom

Replacing a bathroom basin mixer tap is a straightforward task that can be completed by most DIY enthusiasts. You will need to gather the correct tools and materials before you start. These include a new basin mixer tap, an adjustable spanner, Teflon tape, and a pair of pliers. It is important to turn off the water supply to the basin before you start work. You can do this by turning off the isolation valve under the basin or by turning off the main water supply.

Once the water supply is turned off, you need to remove the old basin mixer tap. To do this, use the adjustable spanner to loosen the nuts that are holding the tap to the basin. Once the nuts are loose, you can pull the tap away from the basin. If the tap is stuck, you can use the pliers to gently pry it loose.

Once the old tap is removed, you need to prepare the new tap for installation. To do this, wrap Teflon tape around the threads of the tap's water inlet pipes. This will help to create a watertight seal when the tap is installed.

Next, you need to connect the water inlet pipes to the basin. To do this, push the pipes through the holes in the basin and then tighten the nuts that are holding them in place. Make sure that the nuts are tightened securely, but do not overtighten them as this could damage the basin.

Once the inlet pipes are connected, you can now install the new tap. To do this, push the tap into the holes in the basin and then tighten the nuts that are holding it in place. Again, make sure that the nuts are tightened securely, but do not overtighten them.

Once the new tap is installed, you need to turn on the water supply and check for leaks. If there are any leaks, you will need to tighten the nuts on the water inlet pipes or the tap body until the leaks stop.

Replacing a basin mixer tap is a simple task that can be completed in a matter of minutes. By following these simple steps, you can save yourself the cost of calling a plumber.