How To Replace Basin Taps In The Bathroom

Replacing basin taps in the bathroom is a relatively simple task that can be completed in a few hours. However, it is important to follow the correct steps to ensure that the job is done properly and safely. In this article, we will discuss the essential aspects of how to replace basin taps in the bathroom, including the tools and materials you will need, the steps involved in the process, and some troubleshooting tips.

Tools and Materials

Before you begin, you will need to gather the following tools and materials:

New basin taps
Adjustable wrench
Plumber's putty
Teflon tape
Bucket
Screwdriver
Allen key (if required)

Steps

Once you have gathered your tools and materials, you can begin the process of replacing the basin taps. Follow these steps carefully:

1. Turn off the water supply:

The first step is to turn off the water supply to the basin. This is usually done by turning off the stopcocks located under the basin. If there are no stopcocks, you will need to turn off the main water supply to the house.

2. Remove the old taps:

Once the water supply is turned off, you can remove the old taps. To do this, use an adjustable wrench to loosen the nuts that are holding the taps in place. Once the nuts are loose, you can remove the taps by hand.

3. Clean the surface:

Before installing the new taps, it is important to clean the surface of the basin where the taps will be mounted. This will help to ensure that the new taps are properly sealed and will not leak.

4. Apply plumber's putty:

Once the surface is clean, you can apply a bead of plumber's putty around the base of the new taps. This will help to create a watertight seal between the taps and the basin.

5. Install the new taps:

Now you can install the new taps. To do this, simply insert the taps into the holes in the basin and tighten the nuts that are holding them in place. Be careful not to overtighten the nuts, as this could damage the taps.

6. Connect the water supply:

Once the taps are installed, you can connect the water supply. To do this, simply turn on the stopcocks under the basin or the main water supply to the house. Check for leaks and tighten any nuts that are leaking.

Replacing basin taps in the bathroom is a relatively simple task that can be completed in a few hours. By following the steps outlined above, you can ensure that the job is done properly and safely.