How To Replace Bathroom Light Fan Switch

How to Replace a Bathroom Light Fan Switch

Updating the switch that controls your bathroom's light and fan combination is a simple project that can be completed in under an hour. Before you begin, gather your tools and materials. You'll need a new switch, a screwdriver, and wire cutters. You should also turn off the power to the bathroom at the circuit breaker before you start working.

Once you've gathered your materials and turned off the power, you can begin the process of replacing the switch. The first step is to remove the faceplate of the switch. This is usually held in place by screws or clips. Once the faceplate is removed, you'll see the switch itself. It will be held in place by two screws. Remove these screws and pull the switch out of the electrical box.

Next, you'll need to disconnect the wires from the old switch. There will be two or three wires connected to the switch, depending on whether the switch has a light and a fan or just a light. Use the wire cutters to cut the wires close to the switch. Once the wires are disconnected, you can remove the old switch from the electrical box.

Now you're ready to install the new switch. First, connect the wires to the new switch. The wires will be color-coded, so it's important to connect the wires to the correct terminals on the switch. Once the wires are connected, push the switch back into the electrical box and secure it with the screws.

Finally, you can install the faceplate. Line up the faceplate with the switch and snap it into place. Turn the power back on at the circuit breaker and test the new switch to make sure it's working properly.

Replacing a bathroom light fan switch is a simple project that can be completed in under an hour. By following these steps, you can easily update the switch and get your bathroom's light and fan working properly again.