How To Replace Pop Up Bathroom Sink Plug

How to Replace a Pop-up Bathroom Sink Plug

A pop-up sink plug is a convenient way to seal the drain of a bathroom sink. It allows you to fill the sink with water as needed, and then simply press the top of the plug to close it. Over time, however, the plug may become worn or damaged, and it may need to be replaced.

Replacing a pop-up sink plug is a relatively simple task that can be completed in a few minutes. Here are the steps on how to do it:

Materials you'll need:

New pop-up sink plug
Adjustable wrench
Phillips head screwdriver

Step 1: Remove the old plug

Use the adjustable wrench to loosen the nut that holds the old plug in place. Once the nut is loose, you can pull the old plug out of the sink drain.

Step 2: Inspect the drain assembly

Before installing the new plug, take a moment to inspect the drain assembly. Make sure that the rubber washer is in place and that there are no cracks or damage to the drain body.

Step 3: Install the new plug

Place the new plug into the drain assembly. Make sure that the rubber washer is seated properly. Tighten the nut by hand until it is snug. Then, use the adjustable wrench to tighten the nut further, but do not overtighten.

Step 4: Test the plug

Turn on the water and fill the sink. Press the top of the plug to close it. The water should stop draining. If the water continues to drain, check to make sure that the rubber washer is seated properly and that the nut is tight.

Step 5: Replace the drain cover

Once the plug is installed and working properly, you can replace the drain cover. Use the Phillips head screwdriver to tighten the screws that hold the drain cover in place.

Replacing a pop-up sink plug is a simple task that can be completed in a few minutes. By following these steps, you can ensure that your sink drain is working properly and that your bathroom is looking its best.