How To Replace Pop Up Stopper In Bathroom Sink

How to Replace a Pop-Up Stopper in a Bathroom Sink

A pop-up stopper is a type of drain stopper that is used in bathroom sinks. It is a simple device that consists of a stopper that is attached to a rod, which is in turn attached to a lever. When the lever is lifted, the stopper pops up and blocks the drain. When the lever is lowered, the stopper drops down and allows water to flow through the drain.

Pop-up stoppers can become worn or damaged over time, and may need to be replaced. Replacing a pop-up stopper is a relatively simple task that can be completed in a few minutes.

Tools and Materials You Will Need:

New pop-up stopper
Adjustable wrench
Phillips screwdriver
Flashlight (optional)
Bucket or bowl to catch water
Plumber's putty (optional)

Instructions:

1. Turn off the water supply to the sink. Open the faucet to release any remaining water in the drain.

2. Place a bucket or bowl under the sink to catch any water that may leak out.

3. Use the adjustable wrench to loosen the nut that holds the pop-up stopper in place. The nut is located on the underside of the sink, directly below the pop-up stopper.

4. Once the nut is loose, use your fingers to remove the pop-up stopper. If the stopper is stuck, you may need to use a flashlight to see what is holding it in place.

5. Clean the area where the pop-up stopper was installed. Remove any old plumber's putty or debris.

6. Apply a small amount of plumber's putty to the base of the new pop-up stopper. This will help to create a watertight seal.

7. Insert the new pop-up stopper into the drain hole. Tighten the nut by hand until it is snug.

8. Use the adjustable wrench to tighten the nut further. Be careful not to overtighten the nut.

9. Turn on the water supply to the sink and check for any leaks. If there are any leaks, tighten the nut further.

10. Test the pop-up stopper by lifting and lowering the lever. The stopper should open and close smoothly.

Replacing a pop-up stopper is a simple task that can be completed in a few minutes. By following these instructions, you can easily replace a worn or damaged pop-up stopper and get your sink back in working order.