How To Replace The Faucet In Bathroom Sink

How to Replace a Bathroom Sink Faucet

Replacing a bathroom sink faucet is a relatively simple plumbing project that can be completed in a few hours. By following these step-by-step instructions, you can save yourself the cost of hiring a plumber and have a new faucet installed in no time.

Tools and Materials You'll Need:

* New bathroom sink faucet * Adjustable wrench * Basin wrench * Phillips screwdriver * Flathead screwdriver * Plumber's putty * Teflon tape

Step-by-Step Instructions:

1. Turn Off the Water Supply:

* Locate the water shut-off valves under the sink. * Turn both the hot and cold water valves clockwise to turn off the water supply.

2. Disconnect the Water Lines:

* Use an adjustable wrench to loosen the nuts that connect the water lines to the old faucet. * Remove the nuts and water lines.

3. Remove the Old Faucet:

* Use a basin wrench to loosen the mounting nuts that hold the faucet in place. * Once the nuts are loose, lift the old faucet up and out of the sink.

4. Clean the Sink Surface:

* Use a cloth to clean the area around the faucet holes in the sink. * Remove any old plumber's putty or debris.

5. Apply Plumber's Putty:

* Roll out a rope of plumber's putty and form a ring around the base of the new faucet. * Press the putty into place to create a watertight seal.

6. Install the New Faucet:

* Insert the new faucet into the holes in the sink. * Secure the faucet with the mounting nuts by hand-tightening them. * Use a basin wrench to further tighten the nuts, but do not overtighten.

7. Connect the Water Lines:

* Apply Teflon tape to the threads of the new faucet's water connections. * Screw the water lines onto the faucet by hand-tightening them. * Use an adjustable wrench to further tighten the water lines, ensuring a secure connection.

8. Turn On the Water Supply:

* Slowly turn on the water shut-off valves to allow water to flow into the new faucet. * Check for any leaks around the connections.

9. Adjust the Faucet:

* Use a flathead screwdriver to adjust the faucet handles so that they are positioned correctly. * Use a Phillips screwdriver to adjust the aerator, if necessary.