How To Stop My Bathroom Tap Leaking

How to Stop a Leaky Bathroom Tap

A leaky bathroom tap is not just annoying; it can also waste water and increase your water bill. Fortunately, most tap leaks are easy to fix with a few simple tools. By following these steps, you can quickly and easily stop your bathroom tap from leaking.

1. Identify the source of the leak

The first step is to identify the source of the leak. There are three main places where a tap can leak: the washer, the O-ring, or the packing nut. To identify the source of the leak, simply turn on the tap and see where the water is coming from.

2. Turn off the water supply

Once you have identified the source of the leak, you need to turn off the water supply to the tap. To do this, simply locate the shut-off valves under the sink and turn them off. If there are no shut-off valves, you will need to turn off the main water supply to your home.

3. Remove the aerator

If the leak is coming from the aerator, you will need to remove it to replace the washer. To remove the aerator, simply unscrew it from the end of the tap. Be careful not to lose the small washer that is inside the aerator.

4. Replace the washer

Once you have removed the aerator, you can replace the washer. To do this, simply remove the old washer and replace it with a new one. Make sure that the new washer is the same size and shape as the old one.

5. Reattach the aerator

Once you have replaced the washer, you can reattach the aerator. To do this, simply screw the aerator back onto the end of the tap.

6. Replace the O-ring

If the leak is coming from the O-ring, you will need to replace it. To do this, simply remove the old O-ring and replace it with a new one. Make sure that the new O-ring is the same size and shape as the old one.

7. Tighten the packing nut

If the leak is coming from the packing nut, you will need to tighten it. To do this, simply use a wrench to tighten the packing nut until the leak stops. Be careful not to overtighten the packing nut, as this could damage the tap.

8. Turn on the water supply

Once you have replaced the washer, O-ring, or packing nut, you can turn on the water supply and check for leaks. If the leak has stopped, you are finished. If the leak is still there, you may need to repeat the steps above or call a plumber.