Installing 2 Handle Bathroom Faucet

Installing a 2 Handle Bathroom Faucet: A Step-by-Step Guide

Installing a 2-handle bathroom faucet may seem like a daunting task, but it is actually a straightforward process that can be completed in a few hours. With the right tools and a little patience, you can have a new faucet up and running in no time.

Tools and Materials

Adjustable wrench
Basin wrench
Phillips screwdriver
Flat-head screwdriver
Plumber's putty
Teflon tape
New faucet
Shut-off valves

Step-by-Step Instructions

1. Turn Off the Water Supply

Before you begin any work, turn off the water supply to the bathroom. This is usually done by closing the shut-off valves located under the sink.

2. Remove the Old Faucet

Use the basin wrench to loosen the nuts holding the old faucet in place. Once the nuts are loose, you can unscrew the faucet by hand.

3. Clean the Sink

Once the old faucet is removed, clean the sink thoroughly with a damp cloth. This will remove any dirt or debris that could interfere with the installation of the new faucet.

4. Apply Plumber's Putty to the Base of the Faucet

Apply a thin layer of plumber's putty to the base of the new faucet. This will help to create a watertight seal between the faucet and the sink.

5. Install the Faucet

Place the new faucet in the sink and tighten the nuts by hand. Use the adjustable wrench to further tighten the nuts, but be careful not to overtighten them.

6. Install the Handles

Insert the handles into the faucet and tighten the screws with the Phillips screwdriver. Make sure that the handles are tight, but again, be careful not to overtighten them.

7. Connect the Water Supply Lines

Connect the water supply lines to the faucet using the adjustable wrench. Make sure that the lines are tight, but again, be careful not to overtighten them.