Replacing Moen 2 Handle Bathroom Faucet

Replacing a Moen 2-Handle Bathroom Faucet

Replacing a Moen 2-handle bathroom faucet is a relatively simple home improvement task that can be completed in a few hours with the right tools and supplies. Here's a step-by-step guide to help you replace your faucet:

Materials You'll Need

New Moen 2-handle bathroom faucet
Adjustable wrench
Phillips screwdriver
Basin wrench (optional)
Plumber's putty
Teflon tape

Step 1: Turn Off the Water Supply

Before starting, turn off the water supply to the faucet. To do this, locate the shut-off valves under the sink and turn them clockwise until they are fully closed. Open the faucet handles to release any remaining water in the lines.

Step 2: Disconnect the Old Faucet

Use an adjustable wrench to loosen the nuts that hold the water supply lines to the faucet. Once loose, hand-tighten the nuts onto the new faucet. Next, use the basin wrench or pliers to remove the mounting nuts that hold the faucet to the sink. Once removed, lift the old faucet up and out of the sink.

Step 3: Apply Plumber's Putty

Apply a bead of plumber's putty to the bottom of the new faucet base. This will help seal the faucet to the sink and prevent leaks. Press the faucet into place on the sink, making sure it is level and aligned with the handles.

Step 4: Tighten the Mounting Nuts

Tighten the mounting nuts by hand as much as possible. Then, use the basin wrench or pliers to tighten the nuts further, alternating between the two sides to ensure even tightening. Do not overtighten the nuts, as this can damage the faucet.

Step 5: Reconnect the Water Supply Lines

Wrap the threads of the water supply lines with Teflon tape. Screw the lines onto the corresponding water supply valves and tighten them with an adjustable wrench. Make sure the lines are securely connected to prevent leaks.

Step 6: Install the Handles

Insert the handles onto the stems of the faucet. Tighten the handles by hand, then use the Phillips screwdriver to fully secure them. Make sure the handles are aligned and function smoothly.

Step 7: Turn on the Water Supply

Turn on the water supply valves under the sink. Check for any leaks around the faucet base or water supply lines. If there are no leaks, your new Moen 2-handle bathroom faucet is now installed and ready to use.